Blocking up vents in walls.
Chipboard white plastic coated wood. Or is it just a modern habit?
No large screws for bottom support but dal wood instead.
No top support in the framework.
No nailed or screwed floorboards underneath.
Some edges glued flat to the walls with no screws
Screws that are so weak in state the screw-in piece gets damaged with a few turns and some are even rusty. What good is a screw then?
I pulled the entire unit out today. The wood work behind the side of the blocked vent was mouldy and disgusting. The only good things are the pine doors. I am no builder but I do understand the stupid concepts of blocking up vents and causing dampness. As for the little ceiling support there was the danger of the frames collapsing on me. Also if every screw came out it wouldn't have been so time consuming.
Has anybody pulled out units like this before?
This post has been edited by Deepsycher: 07 October 2006 - 12:20 PM